NTPC
APTITUDE SECTION
For this section no special attention is required only rs aggarwal is enough and it also has easy level of English section
TECHNICAL SECTION
For this section u have to b good in the basics. No hard question were asked but u should b careful about your time . It has also some part of very basic general knowledge. The questions were from following topics
14-15 ques on thermodynamics
8-9 ques on dynamics of machines
5-6 ques on machine desine
10-11 ques on turbines
7-8 ques on heat transfer
5-6 ques on operation research & management
8-9 ques on fluid mechanics & machines
(3 votes)
Thr is -ve marking of
Thr is -ve marking of 1/4
Aptitude-50 ques.n : It was simple the quesns frm percentages, work time i guess who hv gvn the paper of CAT 4 them it would be simple there was nothing to prepare
Tech-120 ques.n- It covers all subject which u hv studied in 4 years The ques.n normally on direct formulaes n units .The main subjects frm which they ask the quesn are:
thermal and heat transfer many q on heat transfer through cylinder, wall, sphere
mechanics of solid /SOM mohr circle,eq. bending formulae,
mechanics of fluid/FOM viscosity, mach no.etc,surface tension turbine and pumps -specific speed and unit formulaes
OR- CPM pert formulae time, crash cost
MCTD taylor eq.n, orthogonal cutting
Auto /engine knocking , cycles, SI engine ,CI engine
Tom max acc of piston, unbalancing force primary n secondary, isolation factor,
I have attempt abt 115-130 Q with i think 90% accuracy n ihv cleraed the written xam then follows GDn PI
GD- Love marriagevs Arrange marriage
PI - mixd personal n tech
Written - 85% weightage
GD-5%
PI-10%
This thing of weightage i came 2 know later on but i m telling u in advanc
Post new comment