Crompton
The technical & aptitude test exam was conducted in mumbai have same paper as delhi(as mentioned in earlier paper)
total questions in both papers is 50-50 &time given is half hour for each.
it is total 3 round process.
Tech. & aptitude test.
G.D.
Interview.
(1 vote)
1. mohr circle is used to
1. mohr circle is used to find?
2. Wat wil hapen to height of a capilary tube-
a) increses wit increase in diametr
b) decrease wid increase in diametr
c) inceare wit increase in specific weight
d) decerase wid increase in specific weight
3. Specific speed of turbine signifies
a) rotational speed
b) head
c) flow rate
d) not remember
4. Power of a belt is givn by-
a) mass
b) velocity
c) arc
d) all the above
5. At what temperature celsius nd faherinit is equal-
answer. -40
6. Slenderness ratio of a mild steel is-
a) >80
b) <80
c) >90
d) <90
7. Magnet is made of which iron
8. Which is weakest iron
a) spring
b) bolt
c) or optin yad nahn
9. Magnet north pole represents which direction
10. Speriodizing is a type of which proces
11. Normaling is done at
a) above crystaline temp with quenchng of oils
b) below crystaline temp
12. Rivets r made by which process
a) extrusion
b) cold heating
c) forging
13. y mercury donot stick to the tube
a) cohesive force>adhesive force
b) cohesive force
14. y cage is provided in bearing in between the balls
15. Wear allowance on go no go is for which end
a) go
b) no go
16. If area, length, diametr, stres r doubled what wil hapen to the strain energy?
17. If a spring of stiffnes of k is divided in 4 parts and then joined in paralel then what wil b the resultant stifness
18. ek bearing lubrication ka question tha
19. How can we increase the pressure angle of a gear
20
a) plaster of paris is extracted from bauxite, true / false
b) ek or tha yaad nahi
21. What is 18-4-1 mild steel?
18 mei kiska kitna composition hai, 4 or 1 mei bhi
22. What is the shape of bending moment of cantilever with udl over it?
23. Surface measurement RA is taken in which units?
a) micron
b) mm2
c) dnt remember
24. In which fit clearance wil b more for hole and shaft?
h6g8
h6e8
h9f9
h9d8
25. If spring is in compressive stresses then major stresses wil b
26. Velocity ratio of gear wil b equal at which point?
27. How much is thermal efficecy of internal combustion engine?
28. Internal spur gear is mass produced by which process
29. ek hooke joint ka tha question?
bahut saare numerical the atleast 8-10 or last k 3 question true / false the?
Post new comment